LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Telescope Motor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Connector Clip, Telescope Drive Motor Assembly Connector, 2 Pan Head Tapping Screws & Telescope Drive Bracket
    GM425435Courtesy of GENERAL MOTORS CORP.
  1. Install the telescope drive bracket (5) to the jacket assembly.
  2. Install the pan head tapping screw (3) to the telescope drive bracket (5).
    NOTE: Refer to Fastener Notice in Cautions and Notices.

    Install the guide retainer bolts.

    Tighten:  Tighten the screw to 7 N.m (62 lb in).

  3. Install the telescope drive motor assembly (2) to the telescope drive bracket (5).
  4. Install the 2 pan head tapping screws (4) to the telescope drive bracket (5).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  5. Install the connector clip (1) to the telescope drive motor assembly connector (2).
    6. Fig 2: Cable Assembly & Telescope Drive Motor Assembly
    GM425430Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Inflator Module Coil Caution in Cautions and Notices.
  6. Connect the cable assembly (2) to the telescope drive motor assembly connector (1).
  7. Remove the steering column from J 41352 .
  8. Install the steering column. Refer to Steering Column Replacement .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals