LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Telescope Actuator Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: TORX® Head Screws, Lower Trim Cover & Driver Knee Bolster Trim Panel
    GM95692Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. With the column fully extended remove the key from the ignition.
  3. Remove the tilt lever from the steering column. Refer to Tilt Lever Replacement .
  4. Remove the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
  5. Remove the 2 TORX® head screws from the lower trim cover.
    6. Fig 2: Lower Trim Cover Tabs & Steering Column Close Out Trim Cover
    GM446719Courtesy of GENERAL MOTORS CORP.
  6. Separate the retaining tabs on the lower trim cover from the steering column close out trim cover.
  7. Remove the switch wires from the telescope motor assembly, which is routed in clips along the bottom of the lower trim cover.
  8. From the inside of the lower trim cover, push out the telescope actuator assembly switch.
  9. Disconnect the assembly switch connector from the instrument panel wiring harness.
  10. Remove the telescope motor assembly switch and wires from the trim cover.
scientia non olet · About LEMON Manuals