LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Telescope Actuator Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Jacket Assembly & Components
    GM425427Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Insert J 42640 into the bottom of the lower trim cover.
  3. Remove the driver side knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
  4. Remove the following items from the jacket assembly:
    1. Retaining ring (1)
    2. Compression spring (2)
    3. Shoulder bolt (3)
    4. Housing support guide (4)
    5. Fig 2: Cable Assembly & Telescope Drive Motor Assembly
    GM425430Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the cable assembly (2) from the telescope drive motor assembly (1).
    6. Fig 3: Telescope Actuator Assembly, Ball & Telescope Drive Bolt
    GM425432Courtesy of GENERAL MOTORS CORP.
  6. Remove the retaining screws from the telescope actuator assembly (3).
  7. Remove the telescope drive bolt (1) and ball (2) from the actuator assembly.
    8. Fig 4: Telescope Adapter Assembly & Screws
    GM425434Courtesy of GENERAL MOTORS CORP.
  8. Remove the retaining screws (1) from the telescope adapter assembly (2).
  9. Remove the telescope adapter assembly (2).
scientia non olet · About LEMON Manuals