Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Telescope Adapter Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Install the telescope adapter assembly (2) to the jacket assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the actuator retaining screws (1).
Tighten: Tighten the retaining screws to 9 N.m (80 lb in).

Fig 2: Telescope Actuator Assembly, Screws, Ball & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the telescope actuator assembly (3) to the jacket assembly.
Install the actuator retaining screws (4).
Tighten: Tighten the retaining screws to 9 N.m (80 lb in).
1. Install the telescope drive ball (2).
2. Install the telescope drive bolt (1).
  Tighten: Tighten the bolt to 7 N.m (62 lb in).

Fig 3: Cable Assembly & Telescope Drive Motor Assembly

Courtesy of GENERAL MOTORS CORP.

Connect the cable assembly (2) to the telescope drive motor assembly (1).

Fig 4: Housing Support Guide, Shoulder Bolt, Compression Spring & Retaining Ring

Courtesy of GENERAL MOTORS CORP.

Install the following items onto the jacket assembly:
1. Housing support guide (4)
2. Shoulder bolt (3)
3. Compression spring (2)
4. Retaining ring (1)

Fig 5: Installing Steering Column Onto J 41352

Courtesy of GENERAL MOTORS CORP.

Install the driver side knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
Remove J 42640 from the lower steering column trim cover.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.