LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Theft Deterrent Lock Replacement (Manual) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wire Harness Assembly & Steering Column Jacket Assembly
    GM323839Courtesy of GENERAL MOTORS CORP.
  1. Install the steering wheel theft deterrent lock.
  2. Route the wire harness assembly along the steering column jacket assembly.
  3. Remove J 42640  from the steering column. See Special Tools and Equipment .
    4. Fig 2: Wire Harness Assembly & Wire Harness Strap
    GM323836Courtesy of GENERAL MOTORS CORP.
  4. Install the wire harness assembly (1) into the wire harness strap (2).
    5. Fig 3: Wire Harness Straps & Steering Column Tilt Head Assembly
    GM323835Courtesy of GENERAL MOTORS CORP.
  5. Install new wire harness straps (2) to the steering column assembly (1) and the column.
  6. Install the steering column tilt head assembly. Refer to Steering Column Tilt Head Housing Replacement (Telescoping)  or Steering Column Tilt Head Housing Replacement (Manual) .
  7. Install the trim covers to the upper and lower steering column. Refer to Steering Column Trim Covers Replacement (Telescoping)  or Steering Column Trim Covers Replacement (Manual) .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals