LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Wheel Set Nut
    GM309617Courtesy of GENERAL MOTORS CORP.
  1. Install the steering wheel to the steering column, observing the alignment marks.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install a new steering wheel set nut.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

  3. Remove J 42640  from the steering column. See Special Tools and Equipment .
  4. Connect the horn electrical connector.
  5. Install the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
scientia non olet · About LEMON Manuals