LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Shaft Seal, Sensor Retainer, Sensor Assembly, Adapter & Bearing Assembly
    GM678058Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering column. See Steering Column Replacement .
  3. Remove the following from the steering shaft:
    1. Steering shaft seal (4)
    2. Sensor retainer (3)
    3. Sensor assembly (2), refer to Steering Wheel Position Sensor Centering .
    4. Adapter and bearing assembly (1)
    4. Fig 2: View Of Lower Bearing Adapter
    GM1562298Courtesy of GENERAL MOTORS CORP.
  4. Remove the adapter and bearing assembly from the steering jacket assembly.
scientia non olet · About LEMON Manuals