LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1512 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Trim Covers Replacement (Manual) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering wheel from the steering column. Refer to Steering Wheel Replacement .
  3. Remove the tilt lever from the steering column. Refer to Tilt Lever Replacement .
    4. Fig 1: TORX® Head Screws, Lower Trim Cover & Driver Knee Bolster Trim Panel
    GM95692Courtesy of GENERAL MOTORS CORP.
  4. Remove the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
  5. Remove the 2 TORX® head screws from the lower trim cover.
    6. Fig 2: View Of Lower And Upper Steering Column Covers
    GM328807Courtesy of GENERAL MOTORS CORP.
  6. Perform the following steps to remove the lower trim cover:
    1. Tilt the trim cover down.
    2. Slide the lower trim cover back to disengage from the upper trim cover.
    7. Fig 3: TORX® Head Screws & Upper Trim Cover
    GM323848Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 TORX® head screws (2) from the upper trim cover (1).
  8. Remove the upper trim cover (1).
scientia non olet · About LEMON Manuals