LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1511 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Secondary Air Injection (AIR) Vacuum Control Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: AIR Solenoid Valve & Retaining Nut
    GM609796Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR solenoid valve.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the AIR solenoid valve retaining nut.

    Tighten:  Tighten the AIR solenoid valve retaining nut to 7 N.m (62 lb in).

    3. Fig 2: AIR Solenoid Valve & Electrical Connector
    GM610239Courtesy of GENERAL MOTORS CORP.
  3. Install the vacuum hoses to the AIR solenoid valve.
  4. Install the electrical connector to the AIR solenoid valve.
  5. Install the right wheelhouse filler panel. Refer to Wheelhouse Filler Replacement in Body Front End.
scientia non olet · About LEMON Manuals