LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1511 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Secondary Air Injection (AIR) Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the AIR pump.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting bolts.

    Tighten:  Tighten the AIR pump bolts to 9 N.m (80 lb in).

  3. Connect the electric connector to AIR pump.
    4. Fig 1: AIR Pump Mounting Bolts & Bracket
    GM59580Courtesy of GENERAL MOTORS CORP.
  4. Connect the hoses to the AIR pump.
  5. Install the left hand side close-out panel.
  6. Lower the vehicle.
  7. Verify the AIR system for proper operation.
scientia non olet · About LEMON Manuals