Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The embossed arrow on the MAF/IAT sensor indicate the proper air flow direction. The arrow must point toward the engine.

Fig 1: MAF/IAT Sensor

Courtesy of GENERAL MOTORS CORP.

Install the MAF/IAT sensor into the air intake duct at the air cleaner housing.

Fig 2: Air Intake Duct & Clamp

Courtesy of GENERAL MOTORS CORP.

Install the new clamp using the J 22610 . See Special Tools and Equipment .

Fig 3: MAF/IAT Sensor Electrical Connector & Air Intake Duct Clamps

Courtesy of GENERAL MOTORS CORP.

Install the air intake duct to the MAF/IAT sensor and the throttle body.
Install the clamps.
Connect the electrical connector of the MAF/IAT.