LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1511 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knock Sensor Wiring Harness Assembly
    GM54608Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical.
  2. Remove the knock sensor wiring harness assembly.
    3. Fig 2: Knock Sensors
    GM54612Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor.
scientia non olet · About LEMON Manuals