LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1511 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Fuel Filler Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank Fill & Vent Pipe, Fuel Fill Hose & Vent Hose
    GM562230Courtesy of GENERAL MOTORS CORP.
  1. Uncap the opening on the fuel tank.
    2. NOTE: Refer to the Fastener Notice in Cautions and Notices.
  2. Install the fuel fill hose (1) to the fuel tank.

    Tighten:  Tighten the fuel fill hose clamp to 4 N.m (35 lb in).

  3. Install the left fuel tank. Refer to Fuel Tank Replacement (Right)  or Fuel Tank Replacement (Left) .
scientia non olet · About LEMON Manuals