LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1511 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Evaporative Emission (EVAP) System Hoses/Pipes Replacement (Engine Purge Pipe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Manifold EVAP Pipe
    GM419425Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the intake manifold pipe and the EVAP canister purge valve.
  2. Install the EVAP pipe to the intake manifold and the EVAP canister purge valve.
    3. Fig 2: Left Fuel Rail Cover
    GM43560Courtesy of GENERAL MOTORS CORP.
  3. Install the left fuel rail cover.
scientia non olet · About LEMON Manuals