LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1511 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor retaining bolt.

    Tighten:  Tighten the CKP sensor to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
  4. Install the starter. Refer to Starter Motor Replacement in Engine Electrical.
  5. Lower the vehicle.
  6. Connect the negative battery cable.
  7. Program the transmitters. Refer to Transmitter Programming in Keyless Entry.
  8. Perform the CKP System Variation Learn Procedure. Refer to CKP System Variation Learn Procedure 
scientia non olet · About LEMON Manuals