LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1510 (Wiring Systems - Specifications, Component Views And Connector End Views) >> Diagnostic Information and Procedures >> Pull to Seat Connectors >> Terminal Repair

Terminal Repair

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the wire needed to be cut in order to remove the terminal, gently push a small length of the same size wire through the back of the connector cavity until there is enough wire exposed in order to crimp on a new terminal. If the wire was not cut, cut the existing wire as close to the old terminal as possible.
  2. Strip 5 mm (3/16 in) of insulation from the wire.
  3. Crimp a new terminal to the wire.
  4. Solder the crimp with rosin core solder.
scientia non olet · About LEMON Manuals