LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1507 (Manual Transmission -- TREMEC 6-Speed) >> Repair Instructions >> Transmission Vent Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Vent Tube & Retaining Bolt
    GM71535Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission vent tube.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transmission vent tube retaining bolt.

    Tighten:  Tighten the transmission vent tube retaining bolt to 20 N.m (15 lb ft).

  3. Install the reverse lockout solenoid. Refer to Reverse Lockout Solenoid Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals