LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1507 (Manual Transmission -- TREMEC 6-Speed) >> Repair Instructions >> Shift Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Roll Pin, Transmission Shift Rod & Transmission Shift Shaft
    GM71536Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission shift rod to the transmission shift shaft.
  2. Using a drift or punch, install the roll pin (1) to retain the transmission shift rod to the shift shaft.
  3. Pull the transmission shift rod away from the transmission to the middle detent position (NEUTRAL).
  4. Install the transmission to the driveline support assembly, then install the driveline support assembly, transmission and differential to the vehicle. Refer to Driveline Support Assembly Replacement (Automatic Transmission) or Driveline Support Assembly Replacement (Manual Transmission) in Driveline/Axle.
  5. Install the shift control assembly. Refer to Shift Control Assembly Replacement .
scientia non olet · About LEMON Manuals