LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1507 (Manual Transmission -- TREMEC 6-Speed) >> Repair Instructions >> Shift Control Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shift Control Boot, Shift Control Lever & IP Accessory Trim Plate
    GM71519Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control boot over the shift control lever.
    2. Fig 2: Locking The Boot Retaining Tabs
    GM180589Courtesy of GENERAL MOTORS CORP.
  2. Align the shift control boot to the I/P accessory trim plate opening, then press to lock the boot retaining tabs.
  3. Adjust the shape of the boot for appearance, if necessary.
    4. Fig 3: Removing Gear Shift Knob
    GM71520Courtesy of GENERAL MOTORS CORP.
  4. Screw the shift control knob onto the shift control lever until the knob bottoms out.
    5. Fig 4: Shift Control Knob Retainer, Shift Control Knob Button
    GM71521Courtesy of GENERAL MOTORS CORP.
  5. Unscrew the shift control knob just enough to align the retainer slot with the slot on the shift control lever.
  6. Install the shift control knob retainer (1) into the slots and seat fully.
  7. Install the shift control knob button.
scientia non olet · About LEMON Manuals