Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Using the J 41099
, install the reverse lockout solenoid. See Special Tools and Equipment .
Tighten: Tighten the reverse lockout solenoid to 40 N.m (30 lb ft).
- Connect the reverse lockout solenoid electrical connector.
- Slowly raise the rear suspension crossmember to seat to the vehicle frame rails.
- Using ONLY HAND TOOLS, install NEW rear suspension crossmember mounting nuts.
Tighten: Tighten the rear suspension crossmember mounting nuts to 110 N.m (81 lb ft).
- Remove the transmission jack from the rear suspension crossmember.
- Connect the wiring harness and brake pipe clip retainers to the rear suspension crossmember.
- Install the rear transverse spring. Refer to Rear Transverse Spring Replacement in Rear Suspension.
- Remove the tie-off retainers from the muffler assemblies.
- Install the intermediate exhaust pipe to muffler bolts.
Tighten: Tighten the intermediate exhaust pipe to muffler bolts to 50 N.m (37 lb ft).
- Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
- Connect the negative battery cable.
Tighten: Tighten the negative battery cable bolt to 15 N.m (11 lb ft).
- Program the transmitters. Refer to Transmitter Programming in Keyless Entry.
NOTE:
Refer to Fastener Notice in Cautions and Notices.