LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1506 (Antilock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C1282 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The EBCM performs 6 different tests to detect a DTC condition. The numbers below correspond to the numbers in Conditions for Running the DTC.

  1. The yaw rate bias is greater than 7 degrees/second.
  2. The yaw rate input change is greater than 390 degrees/second/second.
  3. The yaw rate input voltage is less than 0.15 volts or greater than 4.85 volts for 1 second.
  4. The yaw rate error is greater than 10 degrees/second 30 times within a drive cycle.
  5. The yaw rate error is greater than 10 degrees/second for 5 seconds. Under this condition, this DTC will set along with DTC C1281.
  6. The yaw rate error is greater than 10 degrees/second with the vehicle speed less than 60 km/h (37 mph) and the acceleration pedal is pressed more than 25 percent of the pedal travel range for 1 second during the VSES activation. Under this condition, this DTC will set along with DTC C1281.
scientia non olet · About LEMON Manuals