LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1505 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Heat Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Plenum Heat Shield Retainer
    GM675295Courtesy of GENERAL MOTORS CORP.
  1. Remove the push-in retainer attaching the air inlet screen and battery heat shield to the plenum panel.
    2. Fig 2: Battery Heat Shield
    GM675299Courtesy of GENERAL MOTORS CORP.
  2. Remove the push-in retainer attaching the battery heat shield to the wheelhouse panel.
  3. Lift the battery heat shield from the ground stud and remove the shield.
scientia non olet · About LEMON Manuals