Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the trim panel to the vehicle.
- Install the 12-volt power supply. Refer to Cigar Lighter Housing or 12 Volt Accessory Power Receptacle Replacement in Instrument Panel, Gages and Console.
- Connect the 12-volt power supply electrical connector.
- Install the inflator bezel to the trim panel.
- Feed the auxiliary air outlet through the hole in the inflator bezel.
- Install the auxiliary air outlet washer and retaining nut.
Tighten: Tighten the nut to 2 N.m (18 lb in).
- Install the inflator switch to the inflator bezel.
- Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
- Align the locating tabs on the trim panel to the holes in the body.
- Seat the clips that retain the trim panel to the body.
- Install the seat belt lower anchor.
Tighten: Tighten the anchor bolt to 70.0 N.m (52 lb ft).
- Install the right rear door sill panel. Refer to Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada) or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL) .
- Install the liftgate sill plate. Refer to DOOR SILL PLATE REPLACEMENT-Lift Gate .
- Install the trim panel-rear quarter upper. Refer to Trim Panel Replacement - Rear Quarter Upper (TrailBlazer, Envoy, Bravada) .
NOTE:
Refer to Fastener Notice in Cautions and Notices.