LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter Upper (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Trim Panel - Rear Quarter Upper (TrailBlazer, Envoy, Bravada)
    GM740432Courtesy of GENERAL MOTORS CORP.
  1. Install the rear upper quarter trim panel to the vehicle.
  2. Install the seat belt retractor to the body.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt that retains the rear seat belt upper guide to the body.

    Tighten:  Tighten the rear seat belt upper guide shoulder bolt to 70 N.m (52 lb ft).

  4. Install the screw that retains the rear upper quarter trim panel to the body.

    Tighten:  Tighten the rear upper quarter trim panel screw to 2 N.m (18 lb in).

  5. Install the cargo net retaining knobs.
scientia non olet · About LEMON Manuals