LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter - Right (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Quarter Trim Panel And Screws
    GM799086Courtesy of GENERAL MOTORS CORP.
  1. Position the trim panel to the vehicle.
  2. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
  3. Index the locating tabs on the trim panel to the holes in the body.
  4. Connect the wiring harness connector to the auxiliary power outlet.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the five screws that the retain the rear quarter trim panel to the body.

    Tighten:  Tighten the rear quarter trim panel screws to 2.5 N.m (22 lb in).

  6. Install the seat belt lower anchor.

    Tighten:  Tighten the seat belt anchor bolt to 70 N.m (52 lb ft).

  7. Install the right rear door sill panel. Refer to Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada)  or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL) .
  8. Install the liftgate sill plate. Refer to DOOR SILL PLATE REPLACEMENT-Lift Gate .
  9. Install the right body side window forward garnish molding. Refer to Garnish Molding Replacement - Body Side Window - Front (TrailBlazer EXT, Envoy XL) .
  10. Install the right body side window rear garnish molding. Refer to Garnish Molding Replacement - Body Side Window - Rear (TrailBlazer EXT, Envoy XL) .
  11. Return the third row seats to the upright position.
  12. Install the cargo shelf.
scientia non olet · About LEMON Manuals