LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter - Left (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Trim Panel - Rear Quarter - Left (TrailBlazer, Envoy, Bravada)
    GM740436Courtesy of GENERAL MOTORS CORP.
  1. Position the trim panel to the vehicle.
  2. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
  3. Index the locating tabs on the trim panel to the holes in the body.
  4. Seat the clips the retain the trim panel to the body.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the seat belt lower anchor.

    Tighten:  Tighten the anchor bolt to 70. N.m (52 lb ft).

  6. Install the left rear door sill panel. Refer to Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada)  or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL) .
  7. Install the liftgate sill plate. Refer to DOOR SILL PLATE REPLACEMENT-Lift Gate ..
  8. Install the left body side upper trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper (TrailBlazer, Envoy, Bravada) .
scientia non olet · About LEMON Manuals