LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Body Side Window - Front (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Garnish Molding - Body Side Window - Front (TrailBlazer EXT, Envoy XL)
    GM798350Courtesy of GENERAL MOTORS CORP.
  1. Install the garnish molding to the vehicle.
  2. Install the seat belt retractor to the body.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt that retains the seat belt anchor to the body.

    Tighten:  Tighten the anchor bolt to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals