LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Interior Trim) >> Repair Instructions >> Assist Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the bezels to the headliner.
  2. Rotate the bezels in order to seat the bezel retaining tabs above the headliner.
  3. Install the front and rear roof panel tabs into the bezels.
    Fig 1: Installing Assist Handle From Roof Panel
    G01718958Courtesy of GENERAL MOTORS CORP.
  4. Ensure the top of the roof panel tab (2) is positioned over the plastic retaining tab (1).
  5. Using a flat bladed tool, carefully push up on the bottom of the front roof panel tab (1) until fully seated.
    Fig 2: Illustrating Top Of Roof Panel Tab Positioned Over Plastic Retaining Tab
    G01718959Courtesy of GENERAL MOTORS CORP.
  6. Using a flat bladed tool, carefully push on the bottom of the rear roof panel tab until fully seated.
  7. Close the bezel covers.
  8. Pull downward on the assist handle to ensure the handle is fully secured to the roof panel.
    Fig 3: Seating Rear Roof Panel Tab With Flat Bladed Tool
    G01718960Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals