LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Body Control Modules) >> Removal & Installation >> Driver Information Center >> Removal & Installation (Without Sunroof)

Removal & Installation (Without Sunroof)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.
  1. Disconnect negative battery cable. Remove overhead console cover retaining screw and remove cover. Release tabs on each side of overhead console assembly and remove overhead console assembly from headliner. See Figure. Disconnect wiring harness connectors. Remove Driver Information Center (DIC) retaining screws and remove DIC.
    2. NOTE: When installing roof console, apply foam tape to wiring harness. Secure wiring harness in proper position to headliner.
  2. To install, reverse removal procedure. Calibrate compass on new DIC. See COMPASS CALIBRATION  under PROGRAMMING.
scientia non olet · About LEMON Manuals