LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1496 (Engine Mechanical - 5.3L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Valley Cover Cleaning and Inspection

Engine Valley Cover Cleaning and Inspection

WARNING: This page is about a different car, the 2003 GMC Envoy XL and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Do not use the valley cover knock sensor oil seals again. Install NEW oil seals during assembly.
  • Do not use the valley cover gasket again. Install a NEW gasket during assembly.
  1. Remove the knock sensor oil seals (1) from the valley cover (2).
  2. Clean the valley cover in solvent.
    CAUTION: Refer to SAFETY GLASSES CAUTION in Cautions and Notices.
  3. Dry the valley cover with compressed air.
  4. Inspect the gasket sealing surfaces for excessive scratches or gouging. Refer to REPLACING ENGINE GASKETS   .
  5. Inspect the valley cover oil seal bores for excessive scratches or gouging.
    Fig 1: Removing Knock Sensor Oil Seals From Valley Cover
    G02129544Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals