LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1493 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear-axle assembly to the vehicle.
  2. Connect the upper control arm to the rear axle. Refer to Rear Axle Upper Control Arm Replacement   in Rear Suspension.
  3. Connect the lower control arm to the rear axle. Refer to Rear Axle Lower Control Arm Replacement   in Rear Suspension.
  4. Connect the rear axle tie rod to the rear axle. Refer to Rear Axle Tie Rod Replacement   in Rear Suspension.
  5. Install the coil springs. Refer to Coil Spring Replacement   in Rear Suspension.
  6. Install the stabilizer shaft to the rear axle. Refer to Stabilizer Shaft Replacement   in Rear Suspension.
  7. Install the caliper assemblies to the rear axle. Refer to Brake Caliper Replacement - Front   in Disc Brakes.
  8. Connect the right rear cable of the park brake to the rear axle. Refer to Park Brake Cable Replacement   in Park Brake.
  9. Connect the left rear cable of the park brake to the rear axle. Refer to Park Brake Cable Replacement   in Park Brake.
  10. Install the propeller. Refer to PROPELLER SHAFT REPLACEMENT - FRONT  in Propeller Shaft.
  11. Connect the rear axle vent tube.
  12. Install the rear tires and the rear wheels. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  in Tires and Wheels.
  13. Fill the axle with lubricant. Use the proper fluid. Refer to Capacities - Approximate Fluid   and to Fluid and Lubricant Recommendations   in Maintenance and Lubrication.
  14. Remove the safety stands.
  15. Lower the vehicle.
scientia non olet · About LEMON Manuals