LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1493 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive pinion. Refer to DRIVE PINION AND RING GEAR REPLACEMENT   . 
  2. Install the differential assembly. Refer to DRIVE PINION AND RING GEAR REPLACEMENT   . 
  3. Adjust the differential side bearing preload. Refer to DIFFERENTIAL SIDE BEARING PRELOAD ADJUSTMENT   . 
  4. Adjust the backlash. Refer to BACKLASH ADJUSTMENT   . 
  5. Perform a gear tooth contact pattern check. Refer to GEAR TOOTH CONTACT PATTERN INSPECTION   . 
  6. Install the brake backing plates. Refer to Disc Brake Backing Plate Replacement - Rear . 
  7. Install the axle shafts. Refer to REAR AXLE SHAFT REPLACEMENT   . 
  8. Install the rear axle housing cover and gasket. Refer to REAR AXLE HOUSING COVER AND GASKET REPLACEMENT   . 
  9. Install the brake caliper brackets. Refer to Brake Caliper Bracket Replacement - Rear   in Disc Brakes.
  10. Install the rear axle. Refer to REAR AXLE REPLACEMENT   . 
  11. Fill the axle with lubricant. Refer to LUBRICANT REPLACEMENT - REAR DRIVE AXLE   . 
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals