LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1492 (Front Drive Axle - 4WD) >> Repair Instructions >> Lubricant Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, 2003 Chevrolet TrailBlazer, and 2002 Oldsmobile Bravada. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the drain plug and the washer.

    Tighten 

    Tighten the drain plug to 32 N.m (24 lb ft).

  2. Fill the differential carrier assembly with lubricant. Use the proper fluid. Refer to Capacities - Approximate Fluid   and Fluid and Lubricant Recommendations   in Maintenance and Lubrication.
    Fig 1: Installing Drain Plug And Washer
    G01597969Courtesy of GENERAL MOTORS CORP.
  3. Install the fill plug.

    Tighten 

    Tighten the fill plug to 32 N.m (24 lb ft).

  4. Install the engine protection shield. Refer to Engine Protection Shield Replacement   in Frame and Underbody.
  5. Lower the vehicle.
    Fig 2: Installing Fill Plug
    G01597970Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals