LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1491 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of grease. If the splines of the slip yoke does not have a sufficient coating of grease, lubricate the shaft with grease (GM P/N 12377985 or equivalent).
  2. Install the propeller shaft into the transmission or transfer case.

    Align the reference marks made during removal.

    Fig 1: Installing Propeller Shaft To Transmission
    G01598204Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft to the rear axle pinion yoke.

    Align the reference marks made during removal.

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the yoke retainers and the bolts.

    Tighten 

    Tighten the bolts to 20 N.m (15 lb ft).

  5. Lower the vehicle.
    Fig 2: Installing Yoke Retainer Bolts
    G01598205Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals