LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1486 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction, Turn Signal Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in Air Bag Restraint Systems.
  2. Remove the upper and lower trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT   .
  3. Tilt the column to the CENTER position.
  4. Disconnect the connectors from the turn signal and multifunction switch assembly.

    Remove 2 pan head tapping screws from the turn signal and multifunction switch assembly.

  5. Remove the turn signal and multifunction switch assembly.
    Fig 1: Removing Turn Signal & Multifunction Switch Assembly
    G01597199Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals