LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1486 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The turn signal switch housing must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.
  1. Slide the turn signal switch housing onto the steering column shaft assembly.
  2. Install the turn signal and multifunction switch assembly. Refer to MULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENT   .
  3. Install the ignition lock cylinder case. Refer to IGNITION LOCK CYLINDER CASE REPLACEMENT   .
  4. Install the steering wheel onto the column. Refer to STEERING WHEEL REPLACEMENT   .
  5. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in Air Bag Restraint Systems.
    Fig 1: Installing Turn Signal Switch Housing To Steering Column Shaft Assembly
    G01597194Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals