LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1483 (HVAC Systems - Manual) >> Diagnostic Information and Procedures >> Re-Calibrating Actuators (Auxiliary HVAC) >> Alternate Method (w/o Scan Tool)

Alternate Method (w/o Scan Tool)

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear all DTCs
  2. Place the ignition switch to the OFF position.
  3. Disconnect the scan tool.
  4. Install the auxiliary HVAC actuator.
  5. Re-connect all previously disconnected components.
  6. Remove the HVAC B fuse for a minimum of 10 seconds.
  7. Re-install the HVAC B fuse.
  8. Place the ignition switch in the RUN position.
  9. Wait 40 seconds for the auxiliary HVAC control module to re-calibrate.
  10. Verify that no DTCs have set as current DTCs.
scientia non olet · About LEMON Manuals