LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1479 (Entertainment System) >> Repair Instructions >> Radio Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console shift lever bezel (Oldsmobile only). Refer to CONSOLE SHIFT LEVER BEZEL REPLACEMENT (OLDSMOBILE) in Instrument Panel, Gages and Console.
  2. Remove the lower closeout/insulator panel (GMC only). Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - INSTRUMENT PANEL (I/P) LOWER (GMC/CHEVROLET) in Instrument Panel, Gages and Console.
  3. Remove the accessory trim plate. Refer to BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER (CHEVROLET) or BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER (GMC/OLDSMOBILE) or to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY (CHEVROLET) or TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY (OLDSMOBILE) in Instrument Panel, Gages and Console.
  4. Remove the 3 screws that retain the radio to the I/P.
  5. Partially remove the radio disengaging the radio rear alignment locator (1) to gain access to the electrical connectors.
    Fig 1: Removing/Installing Radio Retaining Screws & Rear Alignment Locator Pin
    GM718020Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the radio antenna cable.
  7. Disconnect the electrical connectors to the radio.
  8. Remove the radio from the vehicle.
scientia non olet · About LEMON Manuals