LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1479 (Entertainment System) >> Repair Instructions >> Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the instrument panel (I/P) compartment to a full down position.
  2. Disconnect the radio antenna cable (2) from the radio extension cable.
    Fig 1: View Of Radio Antenna Cable To Radio Extension Cable
    GM734416Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower rear portion of the wheelhouse panel. Refer to WHEELHOUSE PANEL REPLACEMENT in Body Front End.
  4. Reach up behind the wheelhouse panel and remove the antenna cable and grommet assembly from the cowl opening (1).
    Fig 2: Locating Cowl Opening
    GM718019Courtesy of GENERAL MOTORS CORP.
  5. Pass the end of the radio antenna cable assembly through the cowl opening (1).
  6. Remove the antenna mast. Refer to Fixed Antenna Mast Replacement .
  7. Open the hood.
  8. Remove the radio antenna cable assembly retaining screws.
    Fig 3: Removing/Installing Radio Antenna Cable Assembly Retaining Screws
    GM718023Courtesy of GENERAL MOTORS CORP.
  9. Pass the antenna cable and grommet assembly through the fender opening.
  10. Remove the radio antenna cable assembly from the vehicle.
scientia non olet · About LEMON Manuals