LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1479 (Entertainment System) >> Repair Instructions >> Antenna Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radio antenna cable assembly to the vehicle.
  2. Pass the antenna cable and grommet assembly through the fender opening.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the radio antenna cable assembly retaining screws.

    Tighten:  Tighten the radio antenna cable assembly screws to 2.8 N.m (25 lb in).

    Fig 1: Removing/Installing Radio Antenna Cable Assembly Retaining Screws
    GM718023Courtesy of GENERAL MOTORS CORP.
  4. Close the hood.
  5. Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
  6. Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
    Fig 2: Locating Cowl Opening
    GM718019Courtesy of GENERAL MOTORS CORP.
  7. Install the antenna cable grommet assembly to the cowl opening.
  8. Install the wheelhouse panel. Refer to WHEELHOUSE PANEL REPLACEMENT in Body Front End.
  9. Install the radio antenna cable (2) to the radio extension cable.
    Fig 3: View Of Radio Antenna Cable To Radio Extension Cable
    GM734416Courtesy of GENERAL MOTORS CORP.
  10. Close the I/P compartment.
scientia non olet · About LEMON Manuals