LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1468 (Engine Exhaust System) >> Repair Instructions >> Exhaust Muffler Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Exhaust Muffler Heat Shield
    GM753690Courtesy of GENERAL MOTORS CORP.
  1. Install the muffler heat shield to the floor panel studs placing the muffler heat shield under the rear part of the converter heat shield.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the muffler heat shield with 5 bolts.

    Tighten:  Tighten the exhaust muffler heat shield bolts to 7 N.m (62 lb in).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals