LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1467 (Automatic Transmission, 4L60-E/4L65-E (Troubleshooting)) >> Diagnostic Information and Procedures >> Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096) >> Machine Set-up

Machine Set-up

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Main Power Switch & Main Function Switch
    GM1212328Courtesy of GENERAL MOTORS CORP.
  1. Verify that the main power switch (1) is in the OFF position.
  2. Place the main function switch (2) in the IDLE position.
    3. Fig 2: Connecting To 12V DC Power Source
    GM1212329Courtesy of GENERAL MOTORS CORP.
  3. Connect J 45096  to the vehicle 12-volt DC power source by connecting the red battery clip to the positive (+) battery post on the vehicle and connect the negative (-) lead to a known good chassis ground.
  4. Turn the main power switch to the ON position.
    5. Fig 3: Filling Supply Tank With Transmission Fluid
    GM1212332Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not overfill the supply vessel. Damage to the unit may result. To verify the fluid level, view the LCD screen display while filling the unit, to ensure the fluid level does not exceed 30 L (32 qt).
  5. Fill the supply tank with Dexron®III/Mercon®, or equivalent, through the fill port.
  6. Install and tighten the fill cap.
    7. Fig 4: Applying Shop Air Supply Hose To Quick-Disconnect
    GM1212333Courtesy of GENERAL MOTORS CORP.
  7. Connect a shop air supply hose to the quick-disconnect on the rear panel marked SUPPLY AIR.
scientia non olet · About LEMON Manuals