LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1467 (Automatic Transmission, 4L60-E/4L65-E (Troubleshooting)) >> Diagnostic Information and Procedures >> Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096) >> Clean-Up

Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096): Clean-Up

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Main Power Switch & Main Function Switch
    GM1212328Courtesy of GENERAL MOTORS CORP.
  1. Turn the main function switch to the IDLE position and allow the supply vessel pressure to dissipate.
  2. Turn the main power switch to the OFF position.
  3. IMPORTANT: A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.
  4. Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
  5. Fig 2: Applying Shop Air Supply Hose To Quick-Disconnect
    GM1212333Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the air supply hose from J 45096  .
  7. Dispose of the waste ATF in accordance with all applicable federal, state, and local requirements.