Locking Differential Clutch Disc Assembly - Assemble (8.0 Inch Axle)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Locking Differential Clutch Disc Assembly

Courtesy of GENERAL MOTORS CORP.

Apply axle lubricant, GM P/N 12378261 or equivalent meeting GM Specification 9986115, to the surface of each disc.
Assemble the right side or bell - end side clutch disc assembly as follows:
1. Install the 1st non-carbon eared disc (3) to the side gear (1).
2. Install the 1st splined disc (4).
3. Install the 2nd non-carbon eared disc (5).
4. Install the 2nd splined disc (6).
5. Install the 3rd non-carbon eared disc (7).
6. Install the guide clips (2) to the clutch discs (2-7).
  Apply grease to the guide clips in order to hold the clips in place on the disc ears.