Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stud into the axle flange.
- Install the 4 washers and the lug nut to the stud.
- Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
- Remove the lug nut and the washers.
- Install the rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.