LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1464 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Stabilizer Shaft Links & Stabilizer Shaft
    GM744889Courtesy of GENERAL MOTORS CORP.
  2. Remove the stabilizer shaft link retaining nuts.
    3. NOTE: Do not pry on the stabilizer shaft link. Use care when removing or installing the stabilizer shaft link in order to avoid tearing or puncturing the stabilizer shaft link boot. Damage to the stabilizer shaft link boot will lead to damage to the stabilizer shaft link.
  3. Disconnect the stabilizer shaft link from the frame.
  4. Disconnect the stabilizer shaft link from the stabilizer shaft and remove the stabilizer shaft link.
scientia non olet · About LEMON Manuals