LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1464 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Links & Stabilizer Shaft
    GM731629Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulator to the stabilizer shaft.
  2. Install the stabilizer shaft insulator clamp.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the stabilizer shaft insulator clamp mounting nut.

    Tighten:  Tighten the stabilizer shaft insulator clamp mounting nut to 70 N.m (52 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals