LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1464 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Shock Absorber Lower Mounting Bolt
    GM731622Courtesy of GENERAL MOTORS CORP.
  2. Install the shock absorber lower mounting bolt.

    Tighten:  Tighten the shock absorber lower mounting bolt to 80 N.m (59 lb ft).

    3. Fig 2: View Of Rear Shock Absorber Upper Mounting Bolt
    GM731620Courtesy of GENERAL MOTORS CORP.
  3. Install the shock absorber upper mounting bolt.

    Tighten:  Tighten the shock absorber upper mounting bolt to 80 N.m (59 lb ft).

  4. Remove the support from the rear axle.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals