LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1464 (Rear Suspension System) >> Repair Instructions >> Rear Axle Tie Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: When installing the rear axle tie rod the bushings inner sleeve off set (largest gap) is towards the rear axle.
    Fig 1: View Of Rear Differential
    GM731614Courtesy of GENERAL MOTORS CORP.
  1. Install the rear axle tie rod to the vehicle.
  2. Install the rear axle tie rod to frame mounting bolt and nut.
    3. Fig 2: Removing/Installing Rear Axle Tie Rod-To-Axle Mounting Bolt
    GM731617Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the rear axle tie rod to the axle mounting bolt and nut.

    Tighten:  Tighten the rear axle tie rod mounting bolts to 195 N.m (144 lb ft).

  4. Remove the rear axle support.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals