LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1463 (Front Drive Axle) >> Repair Instructions >> Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle (A4WD) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
    3. Fig 1: Intermediate Shaft Bearing Assembly Mounting Bolts
    GM761107Courtesy of GENERAL MOTORS CORP.
  3. Remove the intermediate shaft bearing assembly mounting bolts.
  4. Remove the wire harness clip from the intermediate shaft bearing assembly.
    5. IMPORTANT: Do not nick or cut the inboard (oil pan) inner shaft seal.
  5. Remove the intermediate shaft bearing assembly.
scientia non olet · About LEMON Manuals